Week Of April 24, 2007

Digital Indicator - FUZYPRO 8010 1/8 DIN

The FUZYPRO 8010 is a 1/8 DIN microprocesspor based digital indicator. Available with red or green displays. One latchable relay is fitted as standard, plug-in modules allow two more alarm relays, PV retransmission or transmitter PSU.

  • Four-digit LED display
  • Up to 3 alarms
  • transmitter PSU option
  • Min/max value hold
  • Engineering units
  • PC configuration
  • PV restransmit option
  • RS485 comms option

Aqua-Boy Moisture Meter

Aqua-Boy Moisture Meter measures the moisture content of many solid materials quickly and accurately. It provides a direct read-out of percent moisture in seconds. The extensive selection of probes available suits the Aqua-Boy Moisture Meter to very many materials.

The meter is designed for easy portability, fast operation with instantaneous indication and universal use. They are compact, handy units supplied with accessories, in a carrying case. Housed in a robust case, shaped to protect the large dial and controls. Power is supplied to the Aqua-Boy Moisture Meter by a 9 V battery.

See Complete Product Information | Request More Information
   
Babbitt LS 2000 Low Cost Level Switch

The LS2000 is a low-cost level switch that can measure virtually any liquid, dry material or interface of electrically conductive or non-conductive products. The proprietary radio frequency (RF) balanced impedence bridge has exceptional temperature stability, thus eliminating the need to recalibrate the unit from season to season.

When the probe is installed, it is calibrated in absence of material touching the probe. When the desired material comes in contact with the probe, the LS2000 is activated and gives the desired output.

See Complete Product Information | Request More Information
   

Process Chlorine Dioxide Sensor From Sensorex

The CLD series chlorine dioxide sensors utilize amperometric technology for real time chlorine dioxide measurements.  Applications include water treatment disinfection and chlorine dioxide generators. These sensors integrate ATC and provide a fixed 4-20mA output which is temperature compensated. A power supply voltage of 12-24VDC is required. The CLD02 is designed for 0-2ppm measurements and the CLD10 features a measuring range of 0-10ppm. Membrane caps are replaceable and replacement electrolyte can be purchased to maximize service life. Body is constructed of Black PVC and the membrane is constructed of durable Teflon. The FC70 flow cell incorporates a vortex generator which prevents air bubbles from forming on the membrane surface leading to erroneous readings.

See Complete Product Information | Request More Information
 

Flowline - Level, Ultrasonic, Alphasonic, RF Capacitance Transmitters

Flowline has a wide range of non-contact and invasive level transmitter technologies offered in general purpose and intrinsically safe configurations. Flowline is dedicated to providing customers with the most cost effective and technically advanced level solutions for tank inventory monitoring, automation and safety applications.

Specializing in non-contact sensing technology and packaged in advanced thermoplastics, our modular product architecture provides maximum application coverage with unparalleled user flexibility. Flowline sensors offer leading edge performance and are designed specifically for challenging corrosive, ultrapure or waste type liquid media.

See Complete Product Information | Request More Information
    

Pump Controllers from Ktech Industrial Products Inc.

Pump Controllers are installed to automatically operate a pump to control the level of a liquid in a tank. They are used in conjunction with Ktech Multi-Level Float Switches. Use two contacts to start and stop the pump. A relay circuit switches power to the fractional horsepower pump motor or to the three-phase contactor of a large pump motor. Similarly, the switch contacts can be used to operate solenoid valves. Use additional contacts to indicate an alarm condition. These alarms provide an audible and visual signal. The audible signal can be muted after which the warning light remains on until the alarm condition is corrected.

See Complete Product Information | Request More Information
   

NEW!! Drying Air Gun...only $105.00 US

 The unique Nex Flow™ Drying Air Gun Model 48001 is used to dry applied water and solvent based paints rapidly by blowing air at the painted or coated surfaces. Also useful for blow-drying small areas.

Specifications:

  • Maximum inlet pressure: 10 bar(145psi)
  • Working pressure: 3-6 bar(43-87 psi)
  • Air Consumption: 12.3 cfm(350l/min) at 60 psi
  • Air Inlet thread 1/4” NPT

Extruder Rupture Disks

Extruder Rupture Disks are designed for reliable emergency relief of excess pressure since they instantaneously rupture at a specific predetermined pressure range. Skylark Controls model CBP Extruder Rupture Disk is designed specifically for use in plastic extruders. Each assembly consists of a stainless steel body and rupture disk. A rupture disk may be specified for primary relief in applications where pressure buildup can occur so rapidly that the response time of a relief valve is inadequate, such as in a polymerization reaction vessel.

See Complete Product Information | Request More Information
   

NEW!! VortexAC Cabinet Coolers For Electrical Enclosures

Avoid any downtime, with the most affordable, reliable, and easiest to install thermal protection product available for electrical enclosures!

Just as quiet as an air conditioner (about 62 dBA), the Vortex A/C noise level is 93% less than other conventional, vortex type cabinet coolers. When the thermo-statically-controlled Vortex A/C is operating, the decibel level is about the same as normal human conversation!

This next generation, Vortex Cooler features an integral mechanical thermostat to conserve energy and maintain enclosure temperatures within a range of 80° to 90°F. Requiring only a compressed air supply to operate, the UL listed Vortex A/C quickly installs in a 1.5” knockout hole to keep electrical control panels cool, clean and protected.

See Complete Product Information | Request More Information
   

Plastic Butterfly Valves

The Chemline Type 57 is the new updated version of the Type 56 Series. The redesigned hand lever no longer has external metal parts. The Type 57 has a redesigned valve "top flange" and shaft, now conforming to ISO for standardized actuator mounting*. These valves offer a large range of sizes and selection of body, disc and seat materials. This allows them into a wide range of on/off or throttling control applications.

The Chemline DBF Series FRP Damper Butterfly is manufactured by Canada’s foremost fabricator of engineered FRP gas and liquid handling equipment. They have manufactured FRP dampers for demanding process applications since 1967. This is a quality engineered valve designed for corrosive and/or abrasive gasses in FRP large diameter duct systems.

See Complete Product Information | Request More Information
       
Continuous Duty Rocking Piston Diaphram Air Pump

The TUF Pump is a 1/20 horsepower, continuous duty, rocking piston diaphragm air pump for use in pressure or vacuum applications. Its sealed bearings motor requires no lubrication. It can be used as an air supply for bubbler type liquid level controls requiring constant 24/7 operation.

Each pump is able to run non-stop for up to 10,000 hours provided it is used with an Ingram BK-10, BK-20 or BK-30 Bubbler Kit. NOTE: For continuous 24/7 operation, we recommend a yearly pump rebuild using the TUF Pump Rebuild Kit.

See Complete Product Information | Request More Information
       

Topdrain Zero Loss Automatic Drains

  • Zero air loss - Microprocessor controlled.
  • Maintenance free - No strainer needed.
  • Easy installation - Plug and play.
  • Remote alarm connection.
  • Remote monitoring device(opt.) - 1 pc accommodates up to 128 traps.
  • Manual test button.
  • Self recovery from alarm event.
  • Weatherproof.
  • Band heater for anti - Freezing (opt.)
  • 1/2" inlet, 1/2" outlet, large orifice.

Biodegradable Descaler - Dynamic Descaler
Before
After

Dynamic Descaler does not corrode, pit, erode or have any other harmful effects on materials and metals such as; STEEL, IRON, BRASS, COPPER, PLASTIC, FIBER, TEFLON or other metals or materials found in water-based systems or equipment. You can clean your equipment IN-SITU (and sometimes without shutting down the machine). Dynamic Descaler has the ability to dissolve approximately 1.5kg of calcium carbonate scale per gallon in concentrated form. It does not need to be heated up during cleaning.

See Complete Product Information | Request More Information
    

Panel Mount Pressure Instrumentation

Onehalf20 offers a complete line of panel mount pressure instrumentation for a wide variety of applications. Units feature built-in alarm contacts, transducer excitation voltage, and 4-20mA re-transmission.

Some models also offer simultaneous pressure and temperature indication.

See Complete Product Information | Request More Information